How to connect ultrasonic sensor to arduino uno board?

 


Arduino – Ultrasonic Sensor Connect the +5V pin to +5v on your Arduino board. Connect Trigger to digital pin 7 on your Arduino board. Connect Echo to digital pin 6 on your Arduino board. Connect GND with GND on Arduino


Comments

Post a Comment

Popular posts from this blog

Simple Night rider LED pattern arduino uno program.

Image
  void setup(){             pinMode(1, OUTPUT);     pinMode(2, OUTPUT);     pinMode(3, OUTPUT);     pinMode(4, OUTPUT);     } void loop(){         digitalWrite(1, HIGH);     delay(100);     digitalWrite(1, LOW);          digitalWrite(2, HIGH);     delay(100);     digitalWrite(2, LOW);               digitalWrite(3, HIGH);     delay(100);     digitalWrite(3, LOW);          digitalWrite(4, HIGH);     delay(100);     digitalWrite(4, LOW);     digitalWrite(3, HIGH);     delay(100);     digitalWrite(3, LOW);     digitalWrite(2, HIGH);     delay(100);     digitalWrite(2, LOW);          digitalWrite(1, HIGH);     delay(100);   ...
Read more

What is the arduino uno.

Image
   The Arduino Uno is an open-source microcontroller board based on the Microchip ATmega328P microcontroller (MCU) and developed by Arduino.cc and initially released in 2010.[2][3] The microcontroller board is equipped with sets of digital and analog input/output (I/O) pins that may be interfaced to various expansion boards (shields) and other circuits.[1] The board has 14 digital I/O pins (six capable of PWM output), 6 analog I/O pins, and is programmable with the Arduino IDE (Integrated Development Environment), via a type B USB cable.[4] It can be powered by a USB cable or a barrel connector that accepts voltages between 7 and 20 volts, such as a rectangular 9-volt battery. It has the same microcontroller as the Arduino Nano board, and the same headers as the Leonardo board.[5][6] The hardware reference design is distributed under a Creative Commons Attribution Share-Alike 2.5 license and is available on the Arduino website. Layout and production files for some versions of ...
Read more

How to connect Arduino UNO?

  How to connect Arduino UNO? Launch the Arduino IDE (1.8. 0 or later). Connect the board to PC. Select the Arduino UNO WiFi as board in the Tools>Board menu. Select the corresponding serial port in the Tools>Port menu. Upload the ESP Recovery sketch. It is into the UNOWiFiDev. Edition Library. Download it from Library Manager.
Read more